- DIGITAL SOLUTIONS
High-performance thermoplastic plastics recycling.
Two different series based on the same compact INTAREMA® recycling system featuring a short single-screw extruder. Including the INTAREMA® top technologies Counter Current®, Smart Start® and ecoSAVE®. Machines of this type are used for multiple applications in the plastics industry for converting production scrap and industrial waste into pellets. For high refeeding quotas, top-quality recycled pellets and high productivity.
INTAREMA® T without extruder degassing
Ideal for non-printed edge trim, cutting waste, rolls loose leftover film and regrind material.
INTAREMA® TE with degassing
For flexible processing slightly printed film fractions and technical plastics.
Economical and technically better.
Enhanced material intake, greater flexibility, higher throughput thanks to Counter Current®
Extremely easy operation and maximum user-friendliness with Smart Start®
HG D hot die face
with direct drive
Perfect material preparation for the extruder thanks to the preconditioning unit
Reliable, high output thanks to Counter Current® technology and extremely robust design
High-quality end product achieves very high recyclate content when material is returned to the production cycle
Liquid-cooled extruder for efficient and exact temperature control for the extruder zones and high-quality processing of the melt
lower energy consumption, lower production costs and CO2 emissions thanks to ecoSAVE®
Very low operating costs through extremely low specific energy and maintenance costs
Large area ultrafine melt filtration as standard
Compact, space-saving design
How it works
INTAREMA® T and TE
Feeding (1) is automatic and according to customer requirements. In the preconditioning unit (2) the material is cut, mixed, heated, dried, compacted and buffered. Next, the tangentially connected extruder is filled continuously with hot, pre-compacted material. The innovative Counter Current® technology enables optimised intake action across an extended temperature range.
In the extruder screw (3) the material is plasticised, homogenised and, if necessary, degassed in the degassing zone (4) . The melt is then cleaned in the fully automatic, self-cleaning filter (5) . Following this, the melt is conveyed to the respective tool (6) (e.g. pelletiser) under extremely low pressure.
PATENTED ADDITIONAL TECHNOLOGIES
DD – Double Disc
Processing of materials with up to 12% residual moisture with consistently high output
Air Flush Module
Increases drying performance and output while ensuring lower energy consumption and extending plant service life
Optimised large EREMA preconditioning unit
Output up to 30% higher than on conventional extruders thanks to extremely uniform feeding of the tangentially connected extruder
INTAREMA® image folder